Link speed and duplex settings
To set link speed and duplex
Incorrect changes to the link speed and duplex settings might prevent the all-in-one
from communicating with other network devices. For most situations, the all-in-one should be
left in automatic mode. Changes can cause the all-in-one to power cycle. Changes should
only be made while the all-in-one is idle.
On the control , press
button to select Network config., and then press .
button to select Link Speed, and then press .
button to select one of the following settings.
The setting must match with the network all-in-one to which you are connecting
(a network hub, switch, gateway, router, or computer).
Press . The all-in-one will power cycle.
Using the all-in-one control panel