Adjusting the lighter/darker (contrast) setting
The lighter/darker setting affects the lightness or darkness (contrast) of the copy. Use the following
procedure to change the contrast for the current copy job only.
To adjust the lighter/darker setting for the current job
1.
On the all-in-one control panel, press
Lighter/Darker
to see the current contrast setting.
2.
Use the
<
or the
>
button to adjust the setting. Move the slider to the left to make the copy
lighter than the original, or move the slider to the right to make the copy darker than the original.
3.
Press
Start Copy
to save the selection and immediately start the copy job, or press to save
the selection without starting the job.
NOTE
The change in the setting remains active for about two minutes after the copy job
has been completed. During this time, Settings=Custom appears on the all-in-one
control-panel display.
To adjust the default lighter/darker setting
NOTE
The default lighter/darker setting affects all copy jobs.
1.
On the all-in-one control panel, press
Menu
.
2.
Use the
<
or the
>
button to select Copy setup, and then press .
3.
Use the
<
or the
>
button to select Def. Light/dark, and then press .
4.
Use the
<
or the
>
button to adjust the setting. Move the slider to the left to make all of the
copies lighter than the original, or move the slider to the right to make all of the copies darker
than the original.
5.
Press to save the selection.
ENWW
Adjusting the lighter/darker (contrast) setting
123